Flooring Contractor in Cedar Hill, TX - Coated Floors Built on Proper Prep
Bedrock Mansfield Concrete Coatings is a flooring contractor based in Mansfield, TX, and we work in Cedar Hill, grinding, repairing and coating concrete in garages, basements, pool decks, shops and kitchens with epoxy, polyaspartic, polished and stained finishes.
- Fully licensed and insured.
- Free quotes on site.
- We reply within 1 business day.
Cedar Hill homes and the floors we find in them
Cedar Hill is a short drive east of us, with family neighborhoods, hilly streets and a busy run of shops and restaurants. On jobs here we mostly see attached garages on slab foundations. Some still have the original bare concrete, and some have a sealer or a kit coating that's started to lift. There are back patios and pool decks that have seen better days, and business owners call about kitchen and shop floors they need to hose down. It's much the same mix we work on next door in Midlothian.
The age of the house tells me where the prep starts. An older slab can carry years of oil, patch jobs and coats of sealer we have to grind through, while a newer one may still be holding moisture, so I want to see it before we talk finishes.
Floor coatings and concrete work we do in Cedar Hill
A good fit for Cedar Hill garages and workshops that take car traffic and dropped tools, laid over a slab we've ground and tested first.
For shops, warehouses and back rooms around Cedar Hill that need a floor that cleans easily and stands up to carts, forklifts and daily mopping.
A stained, dusty or peeling garage floor is the usual reason a Cedar Hill homeowner calls, and a flake system over a ground slab handles tires and spills.
When you'd rather have your garage back sooner, a polyaspartic topcoat cures faster than standard epoxy and holds its color when the door stays open.
For a game room, home bar or showroom where you want the floor noticed, with a swirled, glossy look no two floors share.
The floor I'd point Cedar Hill restaurant owners to for kitchens with hot water washdowns, fryer grease and steady foot traffic behind the line.
If your slab is sound, we grind and polish the concrete itself, which suits open living areas, retail floors and offices that want low upkeep.
Acid or water-based stain gives a plain gray slab some warmth, and it works well on patios, finished basements and living rooms on slab foundations.
For lobbies, churches and storefronts that want a hard, polished floor with chips of marble or glass set in and ground smooth.
Below-grade rooms and basements on sloped lots usually see more moisture than a garage, so we test the slab before choosing a coating that can handle it.
This is the part I care about most, grinding the top open and filling cracks so a new coating grips clean, sound concrete.
A clear sealer helps keep oil, pet stains and sprinkler water from soaking into driveways, patios and garage floors when a full coating is more than you need.
When a patio, walk or garage floor is flaking or worn on top but solid underneath, an overlay gives it a new surface without a tear-out.
Older slabs that dip, crack or step down between rooms get a pourable layer that flattens them, so tile, wood or a coating can go on top.
Backyard pool decks in Cedar Hill take chlorine, splashing and bare feet, and a textured coating or resurfacing can cover cracks and give you better footing.
Peeling DIY epoxy, old tile adhesive or a failed sealer has to come off first, and we strip it down to bare concrete before anything new goes on.
Get your Cedar Hill floor looked at and priced
Send the form and we'll reply within one business day to set a time. I'll come look at your floor myself, and the estimate is free with no obligation to book.
(817) 405-3758- Based in
- Mansfield, TX 76063
- Hours
- Mon–Fri: 7 AM–10 PM, Sat–Sun: 8 AM–9 PM
What to know before a Cedar Hill floor job starts
The City of Cedar Hill's Building Inspections office issues building permits here, and the city's permit list doesn't name floor coatings either way, so when I'm not sure a job needs one, I ask that office before we start. If it does, we take care of the permit, and the wait for it goes into the schedule we set with you. Any contractor doing permitted work in Cedar Hill has to be registered with the city, separate from a general business license, so that's a fair thing to ask anyone you're thinking of hiring. We're fully licensed and insured.
We drive over from Mansfield for Cedar Hill floors and do the same work in Waxahachie and plenty of other cities nearby. The price mostly comes down to the slab, how much grinding, crack repair and old-coating removal it needs, and after that the floor's size and the system you pick. The schedule turns on the permit question, how dry the slab tests and how long the product needs to cure, and your written estimate lays out the prep and the product for your floor.
Slopes and failed coatings on Cedar Hill properties
Cedar Hill sits at the northern edge of the Balcones Escarpment, where the Texas Hill Country starts, and you can see it in how the streets and yards rise and fall. That's true of the city as a whole and doesn't tell me anything about your lot in particular. Still, a slab set into a slope can pick up moisture from the ground behind it, and moisture under a coating is what pushes it loose. So we test the slab before we pick a product, and if it's too wet, I'll tell you instead of coating it anyway.
The other thing we run into is coatings that gave up early, usually a kit epoxy rolled onto a garage floor nobody ground first. It looks good for a while, then hot tires start pulling it up. We strip it back to bare concrete, because a new coat over a failing one just fails along with it.
How a floor job runs when you call us in Cedar Hill
Here's how it goes from your first call to the final walk-through, so you know who you'll see at each step and what you'll get from it.
Call or send a message
Call (817) 405-3758 or send the form and tell me what kind of floor you have and what's bothering you about it. We'll set a time for me to come take a look.
I check the floor myself
I come out, ask how you use the space and check the slab for moisture, cracks and old coatings. Nothing gets priced until I've seen it, so the number you get fits your actual floor.
Get a written plan and date
You get a written estimate that spells out how we'll prep the floor and which product fits it. Then we pick a date that works around your week.
We prep, finish and walk it
Our own crew does the prep and the finish, with me running the job. Before we pack up, I walk the finished floor with you, so plan to be home for that part.
Questions about floor coatings in Cedar Hill
Do I need a permit to coat my garage floor in Cedar Hill?
Cedar Hill's permit list doesn't name floor coatings either way, so it's worth checking with the city before work starts. The city's permit guide says ordinary minor nonstructural repair and remodeling, like painting, wallpaper, cabinets and similar finish work, doesn't need a permit, while construction, alterations and repairs to a building do. We settle that question before your date, as I explained above.
Can I get my own building permit as a homeowner in Cedar Hill?
Yes, if you own the home and live in it, the city can issue you a permit to do permitted work yourself. If you hire us and the floor job turns out to need one, that part's ours.
How do I request a building inspection in Cedar Hill?
Send the request to the city before 4:00 pm on the day before the day you want the inspection. It only applies to work done under a permit the city has already issued. If your floor job is under a permit we pulled, we keep track of that cutoff so it doesn't hold up your schedule.
Do I need a city permit for concrete work on the sidewalk in front of my Cedar Hill house?
Yes, any work on a City sidewalk or street in Cedar Hill needs a public works permit. That rule is about the city's walks and streets. Your patio, pool deck or garage floor falls under the building permit question above, and if a resurfacing job reaches the city's walk, we sort that out before we start.
How much does an epoxy garage floor cost in Cedar Hill?
Your price depends on what your slab needs, so I give you a written figure after I've looked at it instead of a guess over the phone. Size matters, but prep usually moves it more, things like grinding off an old sealer, filling cracks or working around a damp slab. A flake system, a metallic finish and a polyaspartic topcoat each price differently too.
What is the best floor for a restaurant kitchen in Cedar Hill?
For most commercial kitchens, I'd pick urethane cement, because it stands up to hot water washdowns, grease and the jump between hot and cold that cracks a lot of other coatings. If the new floor is part of a remodel or a change in how the space is used, that's work on the city's permit list, so plan for a permit.
Mansfield, TX
Book your Cedar Hill floor estimate today
Call (817) 405-3758 or send the form, because a quick look at the slab now tells you what it needs before you pick a color or buy a kit.